1.4GHz PIII-s hti 1.79GHz on air. Pic inside, no benchies.

[ol' man]

I figured out my problem and why I could not use my async fsb/dram setting. Apparently it does not work in the first mem slot. If my ram could handle it I bet I could run at 1.78GHz on air. I believe that there are going to be bette rchips than this one out there. 1.87 should not be that hard!

[Bender]

Yummy I didnt think even the 1.4s would be doing that well. I hope I can hit 1.6 with my tualatin celeron 1.2 on a BE6-2. I finally have the time to get its water cooling on so it might. Its a shame they arent as cheep as athlons. I did however see a few 1 GHz P3 tualatins in neweggs refurb section for $80 each shipped. That would be great on a dual board.

[takiwa]

nice o/c ol' man :D I'm sure you'll figure out a way to get more, you always do ;)

[nixie]

Originally posted by ol' man
I figured out my problem and why I could not use my async fsb/dram setting. Apparently it does not work in the first mem slot.

Does the ST6 have async fsb/dram, if so how do enable it and is this only so you can run the ram a less than the fsb, or will it let you run it higher than the fsb (ie fsb @133, ram @166)

[ol' man]

Originally posted by nixie


Does the ST6 have async fsb/dram, if so how do enable it and is this only so you can run the ram a less than the fsb, or will it let you run it higher than the fsb (ie fsb @133, ram @166)

Only 133/100 not 133fsb/166mem fsb.