Via Aqua 1300 question! Need help ASAP!!

[The Spyder]

Hey- im doing plumbing for my watercooler- pumps here tomamorw- on a via aqua 1300- which is in which is out?????
TIA
sPYDER

[athlonnerd]

put it in a bucket of water, on see where the water comes out, just dont poin any pipes up!!! or, most pumps are impeller drivve, this works just like a centrifucal fan, is throws the water out from the center of the impellet, so the outlet will be the hole perpendicular to the impller shaft, other wise i would think the outlet and inlet are maker in the pump

[The Spyder]

"pumps here tommaorw" i dont have it yet- i need someone that does to tell me- -TIA!!!

[athlonnerd]

should be this one, circled, or rather, elipsed. ill bet money its this one.

[cynergy]

he's right

[TonyMc]

Oops double post, please delete.

[TonyMc]

Rule of thumb with most of these pumps: they are used for ponds and mostly are made to be submersable. With that said take a look at the posted picture and picture that pump sitting on the bottom of the pond creating a fountain. You'll notice when you get it tommarow that it will have a cover over the front to keep gunk out when it's submerged in a pond so don't worry you'll know which is which hehe (1300 lable side: out, front: in)

[Iron Hawk]

The one on top (circled above) is the Outlet.

[The Spyder]

I know i checked one of my 90ghp little giant pumps. And yet. i still need my pump to plumb this correctly.......

[ATLPIMP]

99% of the time (in my experiences) the pup sucks in in it's side, and pushes out the top.

[Warlord2]

yup yup

I had to use some goop to seal the impeller housing so make sure you leak test the pump first.

[athlonnerd]

its about the only way to engineer an impeller pump.

[ATLPIMP]

Originally posted by Warlord2
yup yup

I had to use some goop to seal the impeller housing so make sure you leak test the pump first.

So did I... just like everything I've ordered from BECooling. :-/

[The Spyder]

Got it today! The setup is being leak tested!