To all with high FSB

[{PMS}fishy]

What are you guys that are running over 42mhz PCI bus using for PCI cards and HDD?

[Batman@]

the KT333 boards I beleive have a 1/5 divisor that kicks in after 166mhz fsb.... other than that, like people with 170 fsb on a 8kha+(kt266a) are running there pci in like the low to mid 40's.

[Jon]

I've got 3 running PCI frequencies of at least that and have 3 generic Realtek NICs in them, Radeon VIVO, GeForce 3 and a PCI STB Velocity 4400 for video cards, SBLive X-Gamer and Vortex SQ2500 for sound (other uses onboard but I think I disabled it). One uses onboard HPT RAID. Hard drives are a WD 40GB ATA100 7200RPM, Maxtor DiamondMax60 40GB ATA100 7200RPM and two old sub-1GB in RAID 0.

Boards are an EPoX 8K7A+ and 8KHA+ and a Shuttle AK31 3.1.

[12am]

Personally I run at 190fsb with a 1/5 divider giving me a 38.50 mhz frequency, although I get severe data corruption over 40mhz, components are as follows;

Leadtek Gf3ti200
Quantum Fireball LM
Seagate ST18A
Sb Audigy OEM
3com Etherlink XL

[FIZZ3]

I ran 41.5 PCI on these components:

SBLive
3Com 905C-TX-M
Adaptec 2930CU: Plex 40tsi+Plex 8220
onboard IDE: IBM60GXP

and 83Mhz AGP on my Asus GF2 GTS all on a CUSL2 mobo. Biggest problem I had were some flakey transfers over the optical SCSI units.

[Mpegger]

Ran these components @ 44.3 fsb:

PCI
Sound Blaster Live! Plat (not 5.1)
Generic 10/100 NIC card
I/O Magic Video Capture card (its actually a Pinnacle brand)
RealMagic Hollywood Plus DVD Decoder (no longer using)
On-board HighPoint UDMA-66 controller chip
1 60gb WD, and 1 6gb WD connected to the HP controller
1 Pioneer DVD-Rom and 1 Hewlett Packard CDRW drive on standard hard drive controller


And for the AGP I have my GF3 (not Ti) PNY card. The agp slot was at 88.6MHz (I only have 2/3 divider on the BE6 board).

All stable and rock solid.