ax-7 and problem fixed! plz read

[Evilsizer]

ok, to start off with all users having high load and idle temps need to make sure the the screws are not lose (ie not slight above fan or moveable.). I changed fans in my case because one of them was reading 200rpm faster so i thought use that one. While last time i made sure to tighten the screws good i was getting high temps even for running my celeron at 1.2ghz 1.475v. we are talking the 50c , that high temp was causing ue's and errors. So when i changed out fans i tightened the screws alittle more than last time. Go in and check rpm on fans and the rpm for that fan was the same as the other (i marked the fans so not to get them mixed up), but i did notice that idle temps went way down 38c-40c load 43c-45c. Now im back at 1.5ghz with the same temps at idle and load.

Now to make sure i got my temp as low as possible one more AS2 appication. After watching temps for while i saw an increase of 1c-2c at 1.5ghz 1.55v

We all learn together.

[PYROMANIAC]

you need a reply

[packratbob]

wat fans are u using on these intels they seem to be runing a bit hot. wat r ur temps and ambient

[Evilsizer]

temps are as stated in first post but ambient is 33c-35c . i live in tx so it depends on how hot it gets. Also im using a sunon 40cfm fan i just bought a 50cfm sunon fan to see how much that helps. the review of this hsf was with the delta and i did not want the noise so i thought that 40cfm was good enough.