Anyone familiar with this kind of rad?

[everx]

Well heres the rad i have installed in my machine... its really sloppy i know.. it was the first project i had ever done like this and mid way through i got a dremel and pretty much rushed the job. I was mainly curious about the quality of a rad like that because i was thinking about getting a heater core on my next case, or if i should just stick with this one. Sorry if its hard to tell what it looks like.. I didnt want to take it out because it would be too much of a pain to do since i would have to disconnect some of the tubes.
Thanks

[rivercom9]

A heatercore would have been a better way to go. By the looks of it, that looks like one of those low pressure drop coolers Danger Den used to sell. They are decent and should get the job done as long as you dont throw too much at it (Pelts). If you do decide to scrap that, you can turn that hole at the top into a window and just put the HC at the bottom front of the case or above the PSU if you can fit it. Just remember next time to just take your time. The more you will appreciate the time you put into what you do. Happy OCing.

[Wicked Klown]

Looks kinda like the swiftech one. Also you should be able to use a pelt with it. After all take a look at this (http://www.liquidninjas.com/bbs/showthread.php?s=&threadid=1043)

[glass]

where did you get your rad? it looks fine for me,got a shroud underneath? i don't see any reason switchin away from it for replacing it with smaller (and possibly another, dunno if yours is) heatercore..

[johnnyw]

My advice is: if it works in an efficient way and you do not have a reason way getting a heatercore inseide the chassis ( ieconstantly moving it from one place to the other), keep that one, why would you spend more money?