Mcw40-t

[Kato]

Anybody knows if the MCW-40T sells with 1/2" fitting?
Thanks:D

[Wicked Klown]

So far I've looked all over for one and nothing.

[JFettig]

maby request it from swiftech, they may hook you up

[Silversinksam]

Originally posted by Kato
Anybody knows if the MCW-40T sells with 1/2" fitting?
Thanks:D

No they dont, but if you have a little patience and a Dremmel its easily done.

My MCW-40 is 1/2"Id but the two entry and return chambers had to be borred out some, and two 1/2"ID barbs had to be threaded in.

A blurry pic is at the end of this thread
http://forum.oc-forums.com/vb/showthread.php?s=&threadid=108226&highlight=MCW40

(This is before I went with two brass fittings as I was testing a polypropalene on one side) The barbs are threaded in and then I used Marine epoxy just for good measure

[Kato]

Humm...interesting idea SSS.
But can I somehow use 3/8" tube for the MCW40-T, then use some 3/8" to 1/2" adaptor to connect the 3/8" tube to the 1/2" tube in the system?

[Silversinksam]

Originally posted by Kato
Humm...interesting idea SSS.
But can I somehow use 3/8" tube for the MCW40-T, then use some 3/8" to 1/2" adaptor to connect the 3/8" tube to the 1/2" tube in the system?

Sure you can use adapters but the problem at hand is a back pressure issue, the enter and return channels are small. Nothing a dremel cant fix the way I saw it ;)