Antec+Cold Cathode=_______

[Xevuhtess7]

im gettin one of those sweet antec sx1030 cases. is there enough room to fit a 12" cold cathode behind those ventson the front inbewteen the front panel and the metal casing? i want to do that so that it would look like its glowing out from the vents.

[The Spyder]

get a 4inch CC- it will fit right......... then put the 12inch in the bottom of the case......

[Xevuhtess7]

ive only seen 12 inch cold cathodes... where do i get 4 inch ones?

[Spec_Ops2087]

www.pcmods.com



Spec

[FunkDaMonkMan]

um... if I remember right... there should be plenty of room. The only thing i'm not 100% sure about, is if the section is 12" tall.

When i get home from school i'll pull my cc out and stick in in there... and tell u.

[Xevuhtess7]

thanks man

[FunkDaMonkMan]

I have an sx840.. which is smaller than the 1030... and its gunna fit... but just barely. If the acrylic surrounding the actual cc is longer than 12 1/2" then you might have to cut a little off.

[Xevuhtess7]

hmm..... well since the sx1030 is bigger then yours.... i think it will just fit.. most cc's are 12.25 inches aren't they?

[FunkDaMonkMan]

yea... but on my cc kit from www.svcompucycle.com there is an acrylic tube surrounding the actually cc... if u took this tube off then you'd be just fine.

[Xevuhtess7]

thanks man

[FunkDaMonkMan]

no prob.....


it should look pretty cool w/ the light c'mon out the front.

[X2sandman]

that inverter they sell at pcmods.com, can it be used for more than on CC, beucase they are kinda expensive so it would be nice if i could use two CC on one inverter

[Tbird man]

probibly not, they make inverters specifically for two but i havent been able to track down any suppliers(only manufacturers)