• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Temps

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

TerryB

Registered
Joined
Jul 3, 2002
Location
Arizona USA
Are the temp sensors on this board accueate
epox 4g4a+ 2.26a @ 2.64 155 fsb 52 idle 60+ load valcano 7+ hsf pulled of my last board where temps where in the 40+ at load
 
Your temps ar better then mine.

Mine's vapochilled.

83c load and idle (core) in the bios, 2424-2822
10c load and idle (mobo) in the bios, 2424-2822

I now it's the bios because it can't read below zero.

Does someboby have an alternative bios that can read below zero.

Kind regards Martin.
 
My temps are : 39-44C Idle and 52-55C under Load depending on my room temp which varies from 26-33C.

P4 2.26B @ 2.652 (FSB 156)
Vcore 1.625
4g4a+ 2424 bios
Corsair 512 XMS-3200C2
ATI Radeon 8500
SB Audigy
 
k just thought i would pass this along took off HSF which is vacano7+ lapped the bottom nice and flat cleaned off all arctic3 reapplied just enough to cover put back together wala 44c at id@160fsb 2.72 ddr400 yes !!!!!!!!!!!!! sisoft sandra memory bench 3094/3096
 
I've got mid to low 50s at full load in room temps of around 28 with the retail HSF and Thermal Interface Material. Which is interesting stuff by the way-it's like a thin sheet of aluminum with dark grey thermal "stuff" on either side of it. I haven't taken the HSF off since I installed the CPU but I bet this does a decent enough job given the amount of compression from the clamping mechanism. I figure I'll see a perfect impression of my CPU slug on the HSF when I take it off!

I'm getting a 370 to P4 heatsink adapter tomorrow and will try my old Millenium Thermal Solutions Glaciator (original). I'm not sure if it'll be a whole lot better than the retail solution but it certainly can't be worse!
 
I must say the glaciator is significantly better! I'm getting high 40s for full load temps now. Definately a better way to cool this CPU.
 
mine runds around 39-40 idle and 45-48 full load.
[email protected](1.65v).
mine also runs @2.7 but it is kinda unstable.
ax-478
geil-ddr333 turbo(don't buy this i don't recomend this mem)
chainteck g4 ti-4200 special edition.
antec true 430 psu
4g4a+
 
Last edited:
Back