Maze 3 three mounting.

[JoJoMoJo]

Hello fellas got a major problem here. I just recieved a Maze 3 waterblock and pelt. Problem is my KT4 Ultra board is not equipped with four holes for the mounting. Can anyone suggest any urls or any hold downs so I can get this mounted. Thanks

[Lt. Max]

i dont think ur gonna be able to mount it without the holes without major modification..

good luck anyway.

max

[SkiFletch]

nah, you should be able to find a hold down for a maze 3... they dont have any fittings over the center of the die, so you might be able to try a Koolance style hold down if its thin enough

[JoJoMoJo]

Ya I have a koolance waterblock I am replacing. The mounting would work it the feet were just a little longer as the Maze 3 is thicker. Does anyone know if anyone makes one I can order?

[JFettig]

well you can make one, go over to becooling, aquastealth.com

they have a clamp, look at that, they are really simple to make, i got one half done but its not tall enough for that block otherwize i would send it over to ya

[JoJoMoJo]

Thanks Maskedgeek, looking at the aquastealth site i noticed this holddown, ya think this would work on the maze three? if so i think a local trip to the hardware store and this would be easy and quick to make. http://becooling.safeshopper.com/images/b90qnm34.jpg

[The Spyder]

Yeah! but ONLY if you have the coppertopped one.......

[JoJoMoJo]

Dam you, your right! Ill need a peice of aluminum bar to go under the bolt too to disperse the pressure. Im sure Ill be fine than.

[JFettig]

actually with a nylon screw it should be alrite, and thats the one i am talking about, i have a similar one partially made, i just gotta make the center part and stick it together