Chipped PEP66 Copper Insert

[FrankMasterFlash]

Is it bad that I have a couple small chips in the bottom of the pep66 or will Arctic Silver II fill in the holes or do I have to lap it?
I can't seem to clean it any better with alcohol, is there any thing that could clean it better? Toilet bowl cleaner? Something that won't harm it.

[Phil]

Artic silver will probabally do it's job here, I don't recomend lapping alphas as the copper bit isn't so much an insert as a layer, not like the big block you get on the taisol 760

[Bender]

Just leave it, the alpha is smooth enough even with the nick. From what I see it doesn't look deep at all. You should see the bottom of my fop38 you can see the impression left by my core. The bottom of the heatsink actually says Duron 600. I should get a picture of it when I have it off.

[FrankMasterFlash]

Thanks, I did not want to lap it because of the softness of copper. I thought it wouldn't be a problem but I wanted to make sure.