Voltage on KT7-Raid [Archive] - Overclockers Forums

tissimo

12-24-00, 07:07 AM

Is there a way to increase the Voltage over 1.85 on the Abit KT7-Raid... I have seen people with over 1.85 volts and am wondering how to achieve this?

HMOverclocker

12-24-00, 07:27 AM

Read the Article here: http://www.amdzone.com/articleview.cfm?articleid=368 or watch this video: http://www.thevideogeek.com/vr/abit_kt7r_vol_mod.asf, then, you'll get what you want. Good luck.

ChapFou

12-24-00, 11:07 AM

Damn !! this voltage mod looks very complicated !!
Is it the only way to higher the voltage ??!!

Bullet.

kat

12-24-00, 04:08 PM

i have a kt7 raid my core volt ajustments are in the bios

Colin

12-27-00, 10:07 PM

I did the mod today. It’s simple if you have any electronics background, less than five minutes once the board is on your bench. I would recommend ditching the wire leads mentioned in the AMD Zone article and soldering the resistors directly to the pad and transistor. I covered the resistors with heat shrink tubing. There is only one problem, it had no effect on my board. Note this is a very new board, about two weeks old. It still peaks out at 1.85 volts. Perhaps there has been a production change that renders this mod useless.

I have another KT7-R that peaks out at 1.92 volts when set to 1.85 volts. This board is about three months old. As soon as I replace the capacitor I damaged on it, I will try the voltage mod again.

Colin