AH!!!!!!!!!!!!!!!!!!!!!! PLEASE HELP!!

[ReFuGee DaWG]

ok... long story to short... i have AZ11 mobo and 800tbird...
i added dipswitched to it to overclock it...
when i set dips to 950MHz it reads as 800MHz .. anything else.. no boot....
(sorry, but i will also post this in amd section...)

PLEASE someone help me???


thank you VERY much,
ReFuGee DaWG
ULYSSES

[Big Mike]

did you cut the traces too? as i remeber you had to cut certain traces in the PCB to get that to work correctly

[ReFuGee DaWG]

yeah i cut em.......... do you think i didnt cut DEEP enough???
i cut it twice to make sure they were cut...




..........

[Rob Cork]

I dunno about the az11 mobo or this mod for it, but I guess you still have to connect the L1 bridges on the chip to unlock the multiplier. Have you double checked them? They need a really thick coating of graphite if you're using the pencil - just do it a few times if you need to.

[ReFuGee DaWG]

ok... i got 2 kinds of penciles with me.... one with soft wood (white wood too), and one with HARD wood (dark brown..)...

so wich should i use?

[App]

What do you think about using a silver pen? (available in electronics store?)
John

[ReFuGee DaWG]

VERY tight budget...................

........but will look into it


but if that IS the thing..... then would it STILL boot normally even though i cut the traces on the mobo.... and soldered the dipswitches?



thnx,
ReFuGee DaWG
ULYSSES

[Rob Cork]

If the bridges aren't connected properly there's no gaurantee it'll post at all - if only some are connected they may give a nonsensical signal, so that the motherboard doesn't know what multiplier to boot at, or it may try to boot at too high a setting. If yours boots only at the defaul mutliplier, that would suggest none of the bridges are connected (or it's a problem with the dipswtiches). Just out of curiosity, have you got a link to the AZ11 dipswitch mod? This is the first I'd heard of it - I'd only heard of putting dipswitches on an A7V if it didn't have them.

[ReFuGee DaWG]

Rob Cork (Jan 07, 2001 02:53 p.m.):
If the bridges aren't connected properly there's no gaurantee it'll post at all - if only some are connected they may give a nonsensical signal, so that the motherboard doesn't know what multiplier to boot at, or it may try to boot at too high a setting. If yours boots only at the defaul mutliplier, that would suggest none of the bridges are connected (or it's a problem with the dipswtiches). Just out of curiosity, have you got a link to the AZ11 dipswitch mod? This is the first I'd heard of it - I'd only heard of putting dipswitches on an A7V if it didn't have them.



www.overclockers.com/tips158/

i dont think its the dipswitches (atleast i hope not.... )



thnx,
ReFuGee DaWG
ULYSSES