which do i trust

[bennieboyq]

ok first off i have a soyo dragon ultra and in the bios my v is set to 5.75 but on sandra it only says 1.50 which one is correct and what about MBM5 does that one know whats going on?

[The Spyder]

its not "set" in the bios, only displayed, sandra is OFF, and MBM5 is misconfigured, try finding the guide to setting MBM5 u on the dragon ultra~

[Intrepid]

I would trust your bios first

[jlin453]

Yeah, I'm having a pain trying to configure MBM5 for my Soyo Dragon Lite. I'm getting completely different readings compared to MBM5 and my Soyo Monitoring program.

[bennieboyq]

so trust the bios then???? are you having much luck oc this board?

[The VTech]

What version of the Dragon? SY-KT400? 333? P4 setup?

In MBM5 you can usually tell you have it right through simple trial and error. I changed the chipset it was reading until I got the right temp range and compaired from there. For Sandra, I have always found it to be about 1-2 degrees HIGHER than actual temp.
Always trust the BIOS and use that as a base for MBM5 and Sandra.

I have not OC using my SY-KT400 yet but the KT333 oc'ed just fine. :D

[jlin453]

The KT333 Soyo OC's fine until you need the 1/5 divider, which it doesnt have :mad:

[JoT]

I would always trust the BIOS before trusting windows software.