- Joined
- Jan 13, 2003
- Location
- Louisiana, USA
Will that make filling,bleeding,ect easier? Are there any downsides to doing that?
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
Using a resivour with a inline pump...
- Thread starter SleepyGuy
- Start date
- Joined
- Nov 12, 2002
- Location
- Rootstown, OH
yes it is easier, imo. no downsides that i can think of. an upside is that you dont need a "t" joint like you do for a t-line... joints can reduce flow.
- Joined
- Dec 19, 2000
I have somewhat of a cross between inline and resivoir. The resivoir is directly attaced to the inlet of the pump. Construction was made possible by scrap .25 acrylic, a hose barb, some JB weld and a 2 liter screw on top. Filling is a sinch. All you do is squirt water from a watterbottle into the top until your system is bubble free.
OP
- Joined
- Jan 13, 2003
- Location
- Louisiana, USA
- Thread Starter
- #4
Does that 172mm fan remove the need for a shroud?
- Joined
- Mar 21, 2002
- Location
- pittsburgh pa
i would think with that much flow u would get the same results as a 120 but with a shroud it would be awesome...
OP
- Joined
- Jan 13, 2003
- Location
- Louisiana, USA
- Thread Starter
- #6
I guess I dont need to worry about making a shroud then 
