The emphasis is on ease of assembly. I would like to make it so that only a drill, dremel, and torch are required.
Anyway, some explination. The idea here is based on Jet impingement. I have not done any calculations on the subject. This will be revision 1 and all subsiquent blocks will show a bit more research put into them.
It is not built yet, but the parts will be ordered within the next couple of days and HOPEFULLY will be put together by the beginning of Feb.
Any suggestions will be welcome. Just try to avoid "this will totaly suck"
Notes:
Layer 1 is the base with just some dremel cuts in the center with a ceramic wheel.
Layer 2 is just for seperation. It creates the water channel.
Layer 3 is where the inlet and outlets will be soldered to the top rather than tapped in.
Anyway, some explination. The idea here is based on Jet impingement. I have not done any calculations on the subject. This will be revision 1 and all subsiquent blocks will show a bit more research put into them.
It is not built yet, but the parts will be ordered within the next couple of days and HOPEFULLY will be put together by the beginning of Feb.
Any suggestions will be welcome. Just try to avoid "this will totaly suck"
Notes:
Layer 1 is the base with just some dremel cuts in the center with a ceramic wheel.
Layer 2 is just for seperation. It creates the water channel.
Layer 3 is where the inlet and outlets will be soldered to the top rather than tapped in.