I have a P4 1.8B Northwood on my Asus P4S8X with DDR333 Memory overclocked at 2.880Ghz @ 1.65v CAS 2.
All of this has been done on a stock Intel Heatsink with Artic Silver and good case cooling.
So far the only problem I have had with getting it to go higher is the lack of a PCI/AGP frequency lock. I think if they could get me an update that would fix that I could get over 3 Ghz.
I have had the PC Post and partially boot at 2.975Ghz but it is just too much on the video card.
Here is an older pic when I had it running at 2.789Ghz . I have since gotten it stable at 2.880Ghz running at 98 degrees idle and 111 full load.
So far this has been one of the best overclocks on this forum I have seen with this board.
All of this has been done on a stock Intel Heatsink with Artic Silver and good case cooling.
So far the only problem I have had with getting it to go higher is the lack of a PCI/AGP frequency lock. I think if they could get me an update that would fix that I could get over 3 Ghz.
I have had the PC Post and partially boot at 2.975Ghz but it is just too much on the video card.
Here is an older pic when I had it running at 2.789Ghz . I have since gotten it stable at 2.880Ghz running at 98 degrees idle and 111 full load.
So far this has been one of the best overclocks on this forum I have seen with this board.
