Only thing i did different was to use a 50k Variable resistor. With that I am able at any time to twist a dial and go from 1.8-2.2 volts. Works great I soldered my connection instead of using the grabbers by takeing a resistor putting some hot solder on it and touching the appropriate pin, it stuck, clipped the resistor off, than soldered a wire to pin soldered to the leg connected to my VR. Good luck.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.