ms-6309
01-02-01, 06:43 PM
Ok this is the question
my hardware monitor setup in the bios looks like
this when its on default
clkgen spread spectrum :enabled
cpu host clock(mhz) :auto
cpu ratio selection :3.0X
cpu vcore selection auto
its a via chip set ms-6309 cel 533 ppga
128 pc100 / matrox melenium G400 dh
so what should i shange to make it run at 600
my hardware monitor setup in the bios looks like
this when its on default
clkgen spread spectrum :enabled
cpu host clock(mhz) :auto
cpu ratio selection :3.0X
cpu vcore selection auto
its a via chip set ms-6309 cel 533 ppga
128 pc100 / matrox melenium G400 dh
so what should i shange to make it run at 600