ABIT BE6-II VCORE PROBLEMS

[pegasos]

i am an owner of an abit be6-ii and a celeron 600 the problem is that the motherboard gives up to 1.75v for the core. How can i have more voltage? Any good ideas?

P.S. I have the latest bios (UH version) updated with the /cc switch at 1.75 volts it doesnt work.
Also i have updated the bios again with a PII-350 installed (with the /cc switch) either this work. My celleron runs 600@972 for the time but it can go further with a little more voltage. Thanks for helping.

[Tim-]

Doesn't your slotket have any voltage adjustment jumpers? If not, you need one that does. I have a BF6 which is the same board minus the HPT controller, and with the Abit slotket I set the jumper to 1.9v and that becomes the new top voltage available in the bios Vcore range.

[pegasos]

I have an Asus slocket with voltage adjustment but when i set the voltage from the slocket (at 1.75v e.g.) the board does not post (black screen). Thats the second strange story of the board it works at 1.75v with his own voltage but not when i set 1.75v from the slocket....

P.S. When i set the voltage form the slocket the motherboard voltage is at the default values (1.5v)