Ram speed

[sidthafish]

Ok I am a bit confused. I have gone to dip switches on my A7V and my multipler is at 11.0x and my bus freq is at 100.00 mhz. So why is my processor showing up as an 1109 and my Ram speed is at 148. I thought if you used the multiplier and left the freq settings alone that the cpu would run at 1100 and the ram at 133. Also somebody has mentioned that i up my core voltage but to what? Default is 1.9 how much higher than that?

[Big Mike]

Don't get insulted by this, i did it by mistake once. Did you check your jumper settings for the FSB? when you take the board out of jumperfree mode the FSB setting is at like 111 instead of 100, you may be at 111x10 and not know it, you can check that with wcpuid or a similar program.