how to make a 120mm hole?

[ssgohan434]

i have 4 80mm intake slots at front of case, but i need to have a 120mm intake for a radiator/heatercore in my watercooling setup. what can i do??? is there somewhere i can go and they will do it for me??

here is case
http://svc.com/diamblaccasw.html

edit:

internal pic

http://store6.yimg.com/I/svcompucycle_1739_18368515

[LilBuddy]

do you want to put the hole in the front? if you can get that fan bracket out, go at it with a hack saw. or you could use a drill to make the holes bigger and just mount it in the middle. unless you are trying to make a big cutout.

[ssgohan434]

yes, i want to put the hole in the front, where the 4 80 mm holes are. what fan bracket?

[Morbid]

to get the right size... use a CD to make the outline, perfect template for a 120mm hole.

Then use a dremel or whatever to cut it out.

[stool]

For what it would cost to have it done, you are better off doing it yourself.
BTW, LilBuddy, that is the 3.5" HD bays displayed.

Because of the 4 80mm cutouts, I'd remove them, get a piece of sheet aluminum, center and cut out the 120mm hole(use a CD as template as Morbid suggests) in the aluminum, and mount the aluminum in place in the 80mm area using the corner mounting holes. Then you can mount your fan in place easily. It should work fine, and you'll have a much neater job. Remove the areas I've outlined in black.

[ssgohan434]

stool, but is there a place that would do it? and how much $?

[Giblet Plus!]

Send it to me. :D