Overclocking 1.2 t-bird/KT7A-RAID

[mjb68]

My system
Amd 1.2 T-Bird
Abit KT7A-RAID
Voodoo 5 5500
20 g Maxtor 7200 rpm HD
256MB PC133 Mem
300 Watt power supply
Windows 2000 Pro
air cooled and (Arctic Silver)


Would like to overclock, but not burn up could someone give me the setting from top to bottom (new at this know nothing about it)for about 1350, give or take a little.

thanks
Michael Boushie

[Shep]

You are already at the max multiplier for your board, so you can do it one of two ways. You can start upping the FSB from where you are at and see how far you can get or you can bring the multiplier down to 9 and set the FSB to 133 and start raising it from there. If you set it too high it might not boot. If that happens you can try holding down the insert key when it should be booting and it will let it boot at default, sometimes that doesn't work on mine so I have to use the cmos jumper to set everything back to default and start again. I would go for 9@133 to start. Watch your temps and don't let them get too much above 50C. As for you video card I think there is a registry hack to allow it to be overclocked but I'm not sure. Hope this helps.