ashenfang
06-03-03, 09:44 PM
well, my SLK 800 A, AS3, and AS epoxy should be comming tomorrow. So let the mods begin!
Obviously i am changing my CPU cooler, I am going to change my Ti42000 block to an stock amd HSF. I plan on using epoxy to attatch it. I am scared of pulling the old one off though becuase they are on there pretty good and I don't wat to damage the chip. WIll I need to sand it? I have though about lapping the SLK before i get on the CPU.
Will also be adding, Mosfet HS, Ram HS, and HS to ram on vid card as well as northbridge and south bridge. All being epoxed on.
Obviously i am changing my CPU cooler, I am going to change my Ti42000 block to an stock amd HSF. I plan on using epoxy to attatch it. I am scared of pulling the old one off though becuase they are on there pretty good and I don't wat to damage the chip. WIll I need to sand it? I have though about lapping the SLK before i get on the CPU.
Will also be adding, Mosfet HS, Ram HS, and HS to ram on vid card as well as northbridge and south bridge. All being epoxed on.