Where to pencil on Duron 700?????

[KiddieClocker]

I am trying to OC my duron 700 and can't remember what points I need to connect on the CPU for the different multipliers!!!!! Someone Help! Also..... I am running another system on a FIC AZ11 Motherboard and when I set the jumper for 133mhz the board won't boot. My ram is PC133 and my cpu supports it too. What am I doing wronf?!?!?!?!?!

[TechnoFile]

Well, pencil in all four of the L1 bridges on the Duron. Reading the core, they are to the far right. If it doesn't work the first time, you may need to repencil. Just be sure not to cross the streams, it would be bad, very bad. As for your 133Mhz problem.... it sounds like you're trying to set the front-side bus(FSB) to 133Mhz.... which would clock your pc133 ram up to 166(??). Anyway, its most likely that the system itself doesn't support a 133mhz FSB, my A7V certainly doesn't(regardless of RAM). Back your jumper setting off to 100Mhz until you get the Duron unlocked and tested. Then start setting the multiplier up one notch at a time until windows gets unstable. Back off one notch and try it with your FSB, one notch at a time also.

Hope this helps!

[Wega!]

Here is a very good guide to unlock the L1 bridges: http://www.cotty.btinternet.co.uk/unlock.htm
Good Luck

[kat]

this should help