just got this board and installed my 2600+..
I have set the CPU Host Control to enabled in BIOS.. with EasyTune4 (ET4) I can up the FSB but I have found it is not stable so far.. I cannot change the multipler from 12.5 with ET4 so I assume I need to use the dipswitch to choose the multiplier..
from what I can see there is no way to lock the AGP or PCI frequency.. if there is a way please let me know..
how about dividers, how do these work? with ET4 when I up FSB I see AGP/PCI freq increases as well which I think may be the cause of instability when I attempt O/C..
any advice on how to O/C with this board is appreciated..
I have set the CPU Host Control to enabled in BIOS.. with EasyTune4 (ET4) I can up the FSB but I have found it is not stable so far.. I cannot change the multipler from 12.5 with ET4 so I assume I need to use the dipswitch to choose the multiplier..
from what I can see there is no way to lock the AGP or PCI frequency.. if there is a way please let me know..
how about dividers, how do these work? with ET4 when I up FSB I see AGP/PCI freq increases as well which I think may be the cause of instability when I attempt O/C..
any advice on how to O/C with this board is appreciated..