Abit vdd mod ?

jonspd · Jun 30, 2003

Can you use a fixed resistor in place of a VR on this mod and if so what is the ohm, or resistance it need's to be? I'am looking for around 1.9 vdd when bios is set to 1.7.

glock19owner · Jun 30, 2003

OPPAINTER said:
I hooked up a 50k ohm resistor to pin 6 to ground. I think the 50k is an overkill but thats what I used. It actually reads 4.16k ohms right now. I assume a 10k VR would work fine. You measure the VDD off of a mosfet that is near the IC. I personally soldered a wire to the mosfet leg so I could have easy access to read the voltage, it would be impossable to measure when the agp card is in place.

Thread

jonspd · Jun 30, 2003

Ok but what did the 50k ohm resistor put his vdd @?

Abit vdd mod ?

jonspd

Super Speedy Senior

glock19owner

Member

jonspd

Super Speedy Senior

Similar threads