RAID 0 Array and Windows Setup

[greenman100]

I just built a new computer, and Im trying to set up Windows 2000 on a RAID0 array.

I have a Highpoint RockeRAID 100 card, w/ HPT370A chipset.
I am also uing 2 60GB Maxtors.

I set up the array with the BIOS on the card, and start Windows 2000 setup using the bootable CD. Setup starts, and asks me if I want to install any disk drivers. I hit F6, and it tells me to put the disk i drive A. I do, and it reads it for a second, and then goes back and asks me again to insert the disk.:mad:

So, I allow setup to continue. Then, it tells me I have no hard disks in my system. Beautiful.

Any ideas?

[Xaotic]

Redownload and reextract the drivers, it's possible they've been corrupted. Use a different floppy as well, or scandisk the floppy, just in case.

[greenman100]

I used the floppy that came with it. I don't think the drivers are in the right format to be used by Wn2k Setup. ideas?

[Xaotic]

Too many times, I've had bad floppies enclosed. Use this link and follow the device drivers link to get the drivers, BIOS updates, etc.

http://www.highpoint-tech.com/

Make sure that you update the card's BIOS to the same version of the driver that you are using.