My new Buffalo!

[Tony77]

So if you remember my old post "My buffalo" I got a bad stick of Buffalo pc3700, so I just got my new stick. It is still running into errors at 215fsb in prime95 with 7-3-2-2.0. I dont know what to say! I think this stuff is doing better than my old stuff but its hard to tell. Would a burn in help?

Both are BH-5 and the DDR volts are at 2.9 but the board says 3.0.

My corsair pc3200 XMS ll did 215fsb easy. Is my NF7-s not compatible?

[selahrecords]

i'm running my buffalo at 232 on my nf7 2.0 have you messed around with different timings at all?

[Tony77]

of course I have. Ive tried 7-2-2-2, 7-3-2-2, 7-3-2-2, 6-2-2-2, 7-2-2-2.5, 7-3-3-3(dont try this one! :}) Ive tried many other combinations as well.

[Tony77]

hehe I think I was undervolting my crap barton! that may have been why it was consistantly getting errors... the barton needs 2v to break 2.1ghz. Imgagine that. Oh well Im about to replace it!

[Tony77]

I take that back, its not doing 215fsb at 7-2-2-2.0 which i understand is standard.

[Chaos_Being]

I ordered that same stuff, I hope I have better luck :D

[Caffinehog]

Nope... 7-3-3-3 is what the stick is rated to do. If it won't go faster, well, that's your own bad luck.

[Lt. Max]

my buffalo can do 200 fsb 2 5 2 2... it does 205 in memtest even but i think when i play and it gets hotter in my case it crashes.. so why r u all runnin 2 7 2 2? does that let it go a lot faster?

max