What should I do now?

[OLMI]

ok.. i just tried overclocking my 2100+ now finally.. i overclocked it.. and ran prime95 and bam, right away i get the ILLEGAL SUMOUT error.

here's what i have runnin right now. all my system info is in my sig.

2100+ @ 11x200
vcore 1.75 (1.71-1.73 in hardware monitor)
vdimm 2.8

my memory is only 2700 so i ran it with the setting "By SPD" so it's at 333 still.

what should i doooooo?

[trimai]

My XP2400 in a ABIT KT7A is running Prime95 right now at 22*100 (for about two hours already). Vcore at 1.80V and temperature is now 59C. At 1.75V, Prime get errror after about 1 hours. I recommend you increase the Vcore until Prime run stable.

[RedDawg41]

your abit board, which version would that be? and as for your xp2100, have you tested it out @133fsb and just raising the multiplier up, that way you know what speed it can run stable at default, and then up the bin on the vcore one at a time, inwhich you will either find the highest multi with the most vcore on your tbred which will run you rig stable. then run your mem test to see if you can stablized it by finding which mem settings for you crucial mods. You might wanna think about running single channel mode, if you didn't by your ram specifically for dual channel. i.e... move the 2nd stick to the 2nd memory slot. (non-dc)

let me know bro.