!!!Peltiers!!!

[[]V[]r.l3Ac0n]

ok... hi every one im new to the forum, humm..... i got a "?", im making a hardcore over clocked computer with a 1.2 thunderbird, kt7a-raid motherboard,etc... and im wondering how do u set up a peltier? like when you layer it should it go like foam - chip - more sealant foam(around the sides) -heat compound - cold block - peltier - heat compound - water jackit then clip it down? i mean thats how i would do it. but if theres a better way to do this plz get back to me, thx!

[Rocky55]

get a amd spacer.
put artic silver between all layers, or any good thermal grease.
put the spacer on the chip, then the cold plate, then cold side of peltier, then waterblock. use non conductive foam around the cpu like a jacket, also on the bottom of motherboard (under cpu) (condensation is bad) silicone works but is very messy.

good luck