I have a following system
AMD 2100+ (TB-R) with SK-7 & Tt Smart Fan II
512 Mb pc3200 (Samsung)
GA-VAXP rev. 1.2
80 HDD
etc..
In order to overclocking my system, yesterday, I connected
2 soldered spots next to SW1 (to get over 166fsb). After
that my computer can't be booted. So, i disconnected the crossing line with a pin. it looked very sucessful (no damages on MB), but results was the same (my computer can't be booted).
What did i wrong?
I am still confused after reading lots of articles over net.
do i have to modify something on cpu to achieve 166fsb+, or
to use wire trick stuff, or to connecting 2 soldered spots next SW1?
Which one is better for newbie?
please, help. I need the system back for rest of my work soon.
Thanks in advance
AMD 2100+ (TB-R) with SK-7 & Tt Smart Fan II
512 Mb pc3200 (Samsung)
GA-VAXP rev. 1.2
80 HDD
etc..
In order to overclocking my system, yesterday, I connected
2 soldered spots next to SW1 (to get over 166fsb). After
that my computer can't be booted. So, i disconnected the crossing line with a pin. it looked very sucessful (no damages on MB), but results was the same (my computer can't be booted).
What did i wrong?
I am still confused after reading lots of articles over net.
do i have to modify something on cpu to achieve 166fsb+, or
to use wire trick stuff, or to connecting 2 soldered spots next SW1?
Which one is better for newbie?
please, help. I need the system back for rest of my work soon.
Thanks in advance