Is this look good???

[Greasy Burger]

http://www.nastyburger.com/temp.jpg


Look at my +12V, I have a 550watt Antec psu for the rig in my sig. I thought 550watt should be enough and my +12V= 12.224:mad:

[D $hady]

As long as your machine runs stably you should be fine. I've found that MBM5 reports lower voltages than what I get with a multimeter reading (sometimes 0.1 - 0.3+ volts lower on +12V line). Also check what your BIOS reports. Granted it won't be able to show you load voltages but it will give you a general idea of whether or not the software reporting is close.


-- Dave

[Tismedt]

Those numbers are fine. What you want to look for are fluctuations in those numbers under load. A 550w Antec should give you solid voltages. Also you don't want your voltage over spec by very much. Things run hot when they get more juice.

[phpguru]

Right in line. Antec power supplies are very good at keeping good line voltages. As Tismedt said, look for fluctuations, you should expect minor to no fluctuations.

phpguru

[Yodums]

You should definitely should to get your readings using a multi-meter as MBM isn't accurate.

But if those readings are under 100% load, then it should be good.