Heating problems "AMD TB 1200,266 bus

[ReTiCuLeX]

Hi i had bought a Amd Thunder bird 1200mhz 266 bus with an ASUS a7v133 Kt133a chip mother board and iam having problems with my CPU the current temperture is 141F and 59c. Another problem iam having is also when i set in my bios the CPU frequency to 133 and the ram when , i shut down my comp sumtimes it I just get a black screen nstead of it booting up and my comp bios goes back to normal @ 9.0x and 100bus and 100bus for ram how can i stop these problems if so plz reply .Iam looking for a good fan for my CPU i currently have a COOL MASTER fan if u have a website for a really good fan i can order plz post the url thank you.

[stool]

You must make sure your HSF is properly seated on your CPU core, and that you have used a proper amount of thermal compound. I don't have a lot good to say about the CoolerMasters, and if you are looking for a good spot to pick up an ALPHA or GlobalWin, try http://millisec.safeshopper.com/index.htm

[ReTiCuLeX]

Ty for ur help i just dont know why it goes back to defaults when i restart it sum times.

[ReTiCuLeX]

should i get the Alpha its more expensive probally better i want a good fan i was gona over clock to 1.4 but i dont want my CPU at this got damn.

[tim]

stool (Mar 24, 2001 11:36 p.m.):
You must make sure your HSF is properly seated on your CPU core, and that you have used a proper amount of thermal compound. I don't have a lot good to say about the CoolerMasters, and if you are looking for a good spot to pick up an ALPHA or GlobalWin, try http://millisec.safeshopper.com/index.htm


One time, I had the CPU temp like 62c+ on my duron 650@725; I removed the heat sink, reseated it and the whole thing go down to 35C, not under load. Also I used the modified Cooler master with a 80X80 Sanyo Denki fan. And it is a great modification, The CPU never gets higher than 44C under load at 145x5=725mhz. The Sanyo denki fan, called Petit Ace, is fairly quiet, 29dba at 2900 rpm and 36 cfm. I got the fan at Fry's. The spec of the Sanyo fan, part number is 109R0812H4011, is at http://www.sanyo-denki.com/BLDCresult.asp
Now I push harder on the CPU, 145X6.5=870mhz, the CPU temp under prime95 is around 47-48C. I think that is good enough for me though.

[Gunjaa]

Im runnin a Duron 800@933(133x7.0) a A7V133a.
am using thermoengine HS/F was still gettin temps of round 61c full load (ambient room temp here in Brissy,Australia is round 33 lately).
i simply removed powersupply from case and mounted outside (only mini tower,board just fit
) added a blow hole on top with old cpu fan and added a fan blowing on back of cpu socket (this alone dropped temp by 5c).im now runnin 52c full load.

Roll on winter.......