Thunderbird 1.2 overclock question

[Diablo]

I have a thunderbird 1.2 100 mhz running on a KT7a raid abit board L1 bridges connected im running at 133 fsb with 10 multiplier giving me 1.33ghz when i try to increase multiplier to 10.5 or anything above i get windows halted message. Bios boots showing me 1.4 gigahertz but like i said windows wont load any suggestions would be greatly appreciated!

[Thelemac]

Hm...more voltage? If you haven't, check out some of the guides on the front page...very helpful stuff there.

[Diablo]

Thelemac (Apr 17, 2001 02:30 p.m.):
Hm...more voltage? If you haven't, check out some of the guides on the front page...very helpful stuff there.

my vcore is 1.89 volts 3.3v value is 3.46volts

[Fiz]

I have noticed taht the lower I put the VIO the more stability I get. I am running mine at 3.2 right now and it's fine. I started to get crashes after about 4 hours of Quake3, so I lowered it to 3.2V and all is good so far. Couldn't hurt to give it a shot. :)

Fiz

[Diablo]

ok now i got a 300fsb 150x2 with 9 times multiplier geeeez a wall

[Da Whip]

Try increaseing the FSB gradually. Keep trying until you get a problem, then back off a bit.

[ken257]

What is the code on your 1.2 just curious? You could have a stubborn one like mine, they don't all OC that great without some help. The 1.2 I am running now will only go to 1.33 with air and it will not even post anything over 1350, but when things get cold the story changes :)

[Yomama]

Diablo (Apr 19, 2001 12:10 a.m.):
ok now i got a 300fsb 150x2 with 9 times multiplier geeeez a wall

What kind of fan/cooler do you use?

Yo