- Joined
- Mar 1, 2003
- Location
- Georgia
I have 2 new maxtor 80GB serial ATA HDD. I have connected them to my new P4P800 dlx board, P4 2.6c cpu, 2x512MB sticks of Kingston Hyper X 3500 DDRAM. I have gone into BIOS to the IDE Configuration screen and set Onboard IDE Operate Mode to = Enhanced Mode and Configure S-ATA as RAID = yes.
Exit and save.
Then I have looked for the alleged message that is supposed to appear during POST "Press <Ctrl-l> to enter Raid configuration Utiltiy" I do not see this message. By the way is that control L or control I, the font used in the manual leaves that open to interpretation.
Anyway, neither of the S-ATA HDD are being found by the BIOS.
What am I missing here? What have I forgotten to do?
Your helpful suggestions will be greatly appreciated.
Exit and save.
Then I have looked for the alleged message that is supposed to appear during POST "Press <Ctrl-l> to enter Raid configuration Utiltiy" I do not see this message. By the way is that control L or control I, the font used in the manual leaves that open to interpretation.
Anyway, neither of the S-ATA HDD are being found by the BIOS.
What am I missing here? What have I forgotten to do?
Your helpful suggestions will be greatly appreciated.
Last edited: