- Joined
- Jun 5, 2003
- Location
- B.C. Canada
I just put together the system shown in the sig. and everything works fine but I would like more out of the CPU.
I am running 10 x 200fsb stable but as soon as I try to bring the multi up to 10.5 it will not post. I either get the siren noise or a message about "CPU unusable or something has changed"
I go back to multi =10 and everything is fine.
CPU is XP1700 DUT3C JIUHB 0308WPMW
NF7-S ver 2 bios 18
CPU temp is 38 under load, sys. board is 32deg.
Memory timings at 8-3-3-3 using 3/3 FSB/Dram (400) using Dimm slot 2 and 3 in dual channel mode.
CPU fan and overheat protection disabled in BIOS.
Vcore set at 1.8, all other voltages at default. Higher Vcore doesn't help.
I read something about a L12 mod to change default CPU speed from 133 to 166.
Help appreciated.
Malph
I am running 10 x 200fsb stable but as soon as I try to bring the multi up to 10.5 it will not post. I either get the siren noise or a message about "CPU unusable or something has changed"
I go back to multi =10 and everything is fine.
CPU is XP1700 DUT3C JIUHB 0308WPMW
NF7-S ver 2 bios 18
CPU temp is 38 under load, sys. board is 32deg.
Memory timings at 8-3-3-3 using 3/3 FSB/Dram (400) using Dimm slot 2 and 3 in dual channel mode.
CPU fan and overheat protection disabled in BIOS.
Vcore set at 1.8, all other voltages at default. Higher Vcore doesn't help.
I read something about a L12 mod to change default CPU speed from 133 to 166.
Help appreciated.
Malph