- Joined
- Aug 17, 2002
- Location
- Vancouver, Canada
Rig Config
ABIT NF7-S v. 2.0 Bios version 1.8
Mushkin Dual Channel PC 3200 2,2,2
Barton 2500+
Enermax 435W PS
Northbridge heatsink replaced with Microcool heatsink
Passive heatsinks added to MOSFET and PLL chips
EXOS water cooler
Ambient Temp. 31 C
Die Temp 46 C
Presently running at 11*206
memory timings at 2,2,2,11
vcore 1.7
vdimm 1.8
vNB 1.6
CPU interface enabled
I have tried everything to get the FSB higher. If I raise the vcore..I get lockup within minutes of running Folding @home. I have tried to relax memory timings..also a no go. For some reason I cannot get a multiplier of 10 to run anything higher than 210, so I am sticking with 11. However, I notice that my 12V rail dips to 11.75 at load. Could this be hindering me to go higher FSB? Any suggestions would be appreciated. With watercooling I thought I could get higher than what I have above!
Thank you.
ABIT NF7-S v. 2.0 Bios version 1.8
Mushkin Dual Channel PC 3200 2,2,2
Barton 2500+
Enermax 435W PS
Northbridge heatsink replaced with Microcool heatsink
Passive heatsinks added to MOSFET and PLL chips
EXOS water cooler
Ambient Temp. 31 C
Die Temp 46 C
Presently running at 11*206
memory timings at 2,2,2,11
vcore 1.7
vdimm 1.8
vNB 1.6
CPU interface enabled
I have tried everything to get the FSB higher. If I raise the vcore..I get lockup within minutes of running Folding @home. I have tried to relax memory timings..also a no go. For some reason I cannot get a multiplier of 10 to run anything higher than 210, so I am sticking with 11. However, I notice that my 12V rail dips to 11.75 at load. Could this be hindering me to go higher FSB? Any suggestions would be appreciated. With watercooling I thought I could get higher than what I have above!
Thank you.