Oveclocking the Duron 750 using the cut bridges.

[DuronManiac]

I wanted to know one thing, is it better to use the L1 bridges for overclocking or to use the L4/6 bridges? Also, is 1.85v the max voltage that can be used with the Duron before the core fries in an inferno?

Just asking to be on the safe side

[rc]

DuronManiac (Apr 27, 2001 01:32 a.m.):
I wanted to know one thing, is it better to use the L1 bridges for overclocking or to use the L4/6 bridges? Also, is 1.85v the max voltage that can be used with the Duron before the core fries in an inferno?

Just asking to be on the safe side
Well...normally the L1's are used but it really depends on the capabilities of your motherboard and bios as far as the ability to adjust FSB and Mult. As for the Vcore there a lot of folks using 2+ volts(with MB mods) with no problems. Be sure you have good cooling and take the voltage up a notch at a time while monitoring the temp. Increased Vcore = Increased Temp so you don't want to use any more than is required to run stable.
coop

[DuronManiac]

ok...cool...thanks for your input.