Water Block Idea

[Sn0rKy]

my idea to make a water block is too..
have a 2/16 inch base...which has copper wires ( about 1/6 ) soldered onto the center

a 1/2inch center
and a 4/16 inch top.. or something around there..
is that a good idea?

has this been done?

[iNSiGMA]

Sorry dude, they're going to hassel you. Your best bet is to get out a shield.

**************ALL FLAMES BELOW THIS POINT**************

[watercoolerking]

do you have a picture?

[Stedeman]

Originally posted by Sn0rKy
my idea to make a water block is too..
have a 2/16 inch base...which has copper wires ( about 1/6 ) soldered onto the center

a 1/2inch center
and a 4/16 inch top.. or something around there..
is that a good idea?

has this been done?
Its your measurements, you need to brake them down
Originally posted by iNSiGMA

Sorry dude, they're going to hassel you. Your best bet is to get out a shield.

**************ALL FLAMES BELOW THIS POINT**************
2/16 = 1/8"
4/16 = 1/4"
but a 1/2" center with or with out the wires soldered on? If it is with out the wires it may be on the thick side and need more flow to cool. Other than that it sounds OK