connected my AMD L1 bridges, slight bleedover... how to fix the bleed?

[gumbi]

All, I connected my L1 bridges with conductive pen, but the material bled over to the opther bridges on one side. I need to break that circuit it creates. I tried a pin and scrape the areas between then clean but I dont think that works so great.

Please copy all replies to glen.rowe@ps.net

thanks!!!!
glen rowe
glen.rowe@ps.net

-------------------------
Glen Rowe
glen.rowe@ps.net

[el]

dont worry use acetone and clean them up and repeat until you don't have done it correctly without any bleedover. I did the same thing my first time. :)

also you might want to do the L6's and L7's while you are at it if you are seriously thinging of over clocking. what chip you got?

[Fiz]

I used a defogger kit and got some crossover, I just took a razor blade and suck it into some alcohol and "cut" the crossover. Be really careful not to cut into the proc, took about 2 min and has worked great ever since. Hope this helps.

Fiz