The title says it all - My board won't post when the FSB is set above 200 and the multi is *below* 11.
It works fine with multipliers 11+, but nothing below. My board (isn't chipset volt modded yet) can only run the FSB up to 215 - but with the higher multipliers there are no problems at all.
Is there any way I can get the lower multipliers to work with the higher FSB? I am currently running at 200 x 12 - if that matters.
It may matter that my chip is socket wire-volt modded to allow the higher range of Vcores (again - my motherboard has a crappy Vcore selection that caps at 1.75 without such a mod... modded brings the cap up to 1.85)
Specs: DLT3C JIUHB 0319 1700+, ASUS A7N8X-DLX 2.0, crappy DDR 333 RAM, BIOS rev. 1006
Thanks in advance!
It works fine with multipliers 11+, but nothing below. My board (isn't chipset volt modded yet) can only run the FSB up to 215 - but with the higher multipliers there are no problems at all.
Is there any way I can get the lower multipliers to work with the higher FSB? I am currently running at 200 x 12 - if that matters.
It may matter that my chip is socket wire-volt modded to allow the higher range of Vcores (again - my motherboard has a crappy Vcore selection that caps at 1.75 without such a mod... modded brings the cap up to 1.85)
Specs: DLT3C JIUHB 0319 1700+, ASUS A7N8X-DLX 2.0, crappy DDR 333 RAM, BIOS rev. 1006
Thanks in advance!