SLK800a temps with NF7-S

GoRm · Sep 16, 2003

Just got a SLK800a with a smart fan 2 and AS3,was kinda disappointed with my temps.
Got Vcore at 1.8 and my temp are 42c-44c/idle 52c-54c/load.
Are these temps about normal,Ive reseated it 3 times

Just trying to get my 1700DLTC to 2.5mhz

Thanks

wannaoc · Sep 16, 2003

Well what setting is the fan at? If not the screaming full power then try that but those tempsaren't horribly bad for air.

I.M.O.G. · Sep 16, 2003

Have you cleaned and reapplied thermal paste between every reseating? Did you follow the application directions on the AS website?

With that overclock and Vcore your temps will probably be a little warm... those might be normal temps. :eh?:

GoRm · Sep 16, 2003

Yes,I cleaned everthing after each reseating as per the AS3 instructions.
The fan is spinning at 4000rpm.

epauls · Sep 16, 2003

How are your case temps? Do you have enough air moving through your case?

Rokk1972 · Sep 16, 2003

how are you reading your temps? Are you using a temp probe, or are you using the onboard sesnor? If you are using the on board sensor, then what BIOS are you running? If you arn't running rev 19 or better then the onboard sensors are not calibrated properly, and you need to flash your BIOS.

My 2 Cents.

mata2974 · Sep 16, 2003

That Abit MB generally gives higher temperatures, I think you are fine!

GoRm · Sep 17, 2003

I have version 2.0 of MB, with bios 18.Im using MB Monitor to view temps. My cases temps are between 25-28c.
Thanks

SLK800a temps with NF7-S

GoRm

Registered

wannaoc

Member

I.M.O.G.

Glorious Leader

GoRm

Registered

epauls

Member

Rokk1972

Member

mata2974

Member

GoRm

Registered

Similar threads