Anybody gotina 1gig 266 AXIA to use the multi 10

[Angry]

Cause I cant go no higher than 9.5, having a prob with fsb lately bt i will get that fix with pc150 ram, anyway I cant use 10x133, It will get to verifying DMI pool data and hang there.

And i have no idea why i cant reach 1.4 like i did that last mounth but since the power went off and the bios reseted i havent been able to get above 1200,

This sux I was a liitle over 1.4 gig and now even with a better cooling fan I still cant get back up there...uuggghhh

Anyway pleas eanswer my "?"


thankyou,
Angry

[Hoot]

I can get 10, 10.5 and 11 reliably, if I adjust the FSB accordingly: IE

10x150
10.5x145
11x124

I don't know why you are experiencing this problem, except it also happened to me a several weeks ago. I'll assume you have re-done your L1 traces several times to make sure they are not the culprit. I thought it was my CPY and darned near ruined it re-soldering the L1 traces too many times. My problem mysteriously went away. I chalk it up to the excellent repeatability of results using the KT7A (sic)
I am using the YH bios revision.

Hoot

[bravo261]

i got the same damn problem and still haven't figured out why. if i set it to 10 or higher, it'll boot just fine but the multiplier automatically runs at 9.5, even though the bios itself still says 10 or whatever. post your solution if you find one.

[Yomama]

Verify that your cpu is still unlocked - otherwise it looks like a mobo issue, possibly a new bios or re-flashing it might help...

Yo

[jgaud]

no problems here

10x133
10x145