- Joined
- Sep 20, 2003
- Location
- London, ON, Canada
Yeah I have a barton 2500 and a NF7-S rev2 (bios 1.8) and OCZ (512x1) 3200, with Enermax 350w psu. For whatever reason I cant raise my fsb to anything above 166 without it being very unstable.. It will load up and everything but when I try to run Prime95 it fails after less then 4 minutes.. I can boot up on everything up to 205 fsb, but if I try to raise vcore to say 1.75 it wont boot up, says it will do harm.. I dont get it.. my cooling is okay 39.5c idle and 48c load using a Volcano 10+ and I have 2in led fans 2 out.. I would have liked to reach 11x210 or 10.5x220 with OCZ 3200 ram which I heard was very possible.. Is there something I'm doing wrong? my ram timings are 2-3-3-6 and my vcore is 1.65-1.68, Vcc is 2.62 (all according to winbond hdoctor)
Can some people give me advice as to why I'm not getting what I should out of my system? I want ATLEAST 200 FSB hence the Dual 400 NF7-S rev2, and 3200 RAM.. geez.. 4 minutes at Prime95's torture test is awful.
Can some people give me advice as to why I'm not getting what I should out of my system? I want ATLEAST 200 FSB hence the Dual 400 NF7-S rev2, and 3200 RAM.. geez.. 4 minutes at Prime95's torture test is awful.