Duron 800 at 1gig

[YucA]

well i did the pencil trick and it seemed to work but i still have a few questions. I have an A7V MB and i had to disable "jumper free mode". I set the Bus Frequency Multiple at 7.5, and CPU external Frequency setting at 133, and it wouldnt boot. THEN i set the CPU Frequency back at 100(default), made the BUS frequency multiple 10, and the voltage to 1.80(on VID on motherboard). With this it booted fine at a 1gig but at the bios my ram frequency was at 100, i switched it to 133 and rebooted and it seems to be running fine. I ran Sandra, and it runs at about 43c normal and 47-48c after playing HL for about an hour. Just wanna see if this all sounds right, or i did something wrong??.. Help a newb out..=)
ohh yea i have an FOP32 with Artic Silver.

[zision]

Your motherboard is the A7V266 with the KT133A chipset, correct?

[!-=sky=-!]

the a7v mobo has a kt133 chip so i dun think it's possible to do 133 fsb
lots of ppl said they can't do 110fsb or higher but me personally can do 124 now and when i lower the multiplier on my duron 750 i can use 133 fsb

[YucA]

zision, yea thats my MB..=)

Thanks for the input, i guess ill try to up the FSB little by little and lower the multiplier.