Innovatek X-flow

[MuEagle05]

Has anyone tried replacing the compression fittings with 1/2" barbs? I replaced the OEM 1/4"ID 3/8"OD compression fittings with 3/8"ID 1/2"OD compression fittings from frozencpu.com, and the retention clip barely squeezes on. I'm wondering if 1/4 NPT with 1/2" barb would work b/c I'm moving up to 1/2" ID tygon?

[Miralcos]

I don't have an Xflow but I do have a rev3.0 waterblock and I believe it has the same fittings. I changed it to 1/2" barbs and it works wonderfully. Hope this helps a bit. :)