nickhi
06-11-01, 06:30 PM
Have double checked and repeated unlocking my Tbird 1000 (266fsb) AXIA, but still don't get it to o/c reliably. It POST's ok with multipliers at 12, 12.5, 8.5, 8, 7.5 and lower. However it just will not POST when I set the multipliers to either 9, 9.5, 10, 10.5. I have set the FSB accordingly with the multiplier to give the same speed but it still fails. ie at 12x100 =1200 runs fine, but 10x120 Fails to POST. The FSB will run fine at 145MHz. I can only think it must be a fault with the unlocking of one of the L1 bridges. So does anyone know how to identify which L1 bridge might be the cause based on the multipliers I can't get to work ?
I have tried adjusting the core voltages and I/O still with no success. currently at 1.8v and 3.5v. idle temp at 36C.
TBird 1000 AXIA 'K'
KT7-A (bios WW, tried ZT but even less success)
Crucial PC133 256MB
Geforce2 Pro
SBLive
300w PSU
Geforce2 Pro
I have tried adjusting the core voltages and I/O still with no success. currently at 1.8v and 3.5v. idle temp at 36C.
TBird 1000 AXIA 'K'
KT7-A (bios WW, tried ZT but even less success)
Crucial PC133 256MB
Geforce2 Pro
SBLive
300w PSU
Geforce2 Pro