WHAT TO DO NEXT

[peewee]

well i got my 1.4 installed, tho i am waiting for my danger den block, im thinking about a pelt now, i have a 13.5 volt 10amp supply laying around which i dont think will run a 156watt pelt, do the lower watt pelts work on this power supply? like a 120watt or so pelt maybe???
i dont want to go to high and get condensation...
also where is the best place for a pelt ? dangerden? and where can i get a better power supply??

[Hoot]

A 156W pelt will draw less current the lower the voltage you run it at. If that 13.5V/10A supply of yours is rated at continuous duty, you can run the 156W pelt with it. If that rating is only peak or intended for a lower duty cycle, it will probably overheat. I doubt it will instantly self-destruct under the load though, so go ahead and give a 156W pelt a try with it.

Hoot

[peewee]

Hoot (Jun 13, 2001 10:53 p.m.):
A 156W pelt will draw less current the lower the voltage you run it at. If that 13.5V/10A supply of yours is rated at continuous duty, you can run the 156W pelt with it. If that rating is only peak or intended for a lower duty cycle, it will probably overheat. I doubt it will instantly self-destruct under the load though, so go ahead and give a 156W pelt a try with it.

Hoot
it if burns the supply out, owell i dont need it , i found it at work... maybe it will run it not to cold to form condensation, but cold enuff to cool my chip beter...