Asus TusL2-C & Celeron 1.1a

The following set up is what I have. Does anyone know the proper settings for the following listed below that would

alow me to overclock the celeron 1.1a to the most stable level on the Asus Tusl2-c.



Asus TusL2-C & Celeron 1.1a
Bios v1012 (Tweaked)
Thermalright SK-6 + Delta 30 CFM Fan
Video Card = VisionTek GeForce3 Ti500 64 MB AGP
RAM = Crucial 2x256 PC133

What settings should I set for the following:

CPU Internal Frequency = Manual
CPU Frequency Multiple = Fixed at 11
FSB:SDRAMCI Freq Ratioo = [?:?:?]
FSB/SDRAM/PCI Freq (MHz) = [?/?/?]

Thanks
CPU Vcore =


SDRAM Timing
SDRAM CAS Latency [?]
SDRAM RAS to CAS Delay [?]
SDRAM RAS Precharge Time [?]
SDRAM Cycle Time (Tras,Trc) [?,?]

I would recommend setting the FSB to 133, and the ratio to 133/133/33 (i.e. as if running stock speeds with a PIII rather than a Celeron). Leave the vcore to default and set the memory to 'Auto' or to the most conservative (highest latency) settings. If that's stable, then you can start to try more aggressive memory settings. If not then try tweaking the vcore to see if you can get it stable.

Thanks deadkenny.