Burn in: How do you do it?

[Hans]

I am asking what your favorite method is, how long you set what where.

And what do you do next after burning in?

hans

[Wega!]

I use Folding@home, when I'm burning a new CPU. I let it burn about 25- 30 hours under full load.
After the burn-in u should be able to run a little faster than before. My Duron woulden't let my pass 900MHz, before I had done some Burn-in, now I'm pass the gig :)

[Hoot]

I just set it up for the highest OC I can get, along with a temp around 50C and use it. Then, from time to time, I check to see if it will go a little faster, a little cooler, or with a lower Vcore. Lazlo Lowenstein agrees. ;D

Hooy

[silent bob]

Ive used SiSoft and let it go until my full load temps =my idle temps from when I started the burn-in usually 2 days or so

[Hans]

Well, thanks for the good advice. I'm all set to do some burnin'.

You guys have really done well with it, I hope I have good luck too.

Best Regards,

hans

[Hans]

Well, thanks for the good advice. I'm all set to do some burnin'.

You guys have really done well with it, I hope I have good luck too.

Best Regards,

hans